Skip to main content
Skip table of contents

The Switch matrix tab. Intersvyaz intercoms

On the Switch matrix tab, you can configure the coordinate matrix-switch settings.

The tab is displayed when the Matrix-switching or Combined 1 connection scheme is selected on the General data tab.

To enter the number of apartments, complete the Matrix capacity field. The apartment matrix will be built automatically.

You can enable auto complete of the matrix by dragging the Auto toggle. If enabled, you can select the checkbox to shift the last matrix element to the front of the table.

You can edit the Matrix table after it's automatically prefilled. This is applicable to Intersvyaz intercoms.

image 57 (5).png

The Switch matrix tab

If the total count of apartments in the matrix is fewer than the number specified in the Apartments tab, calls will be automatically directed to the apartments that appear first in the Apartments tab.

In the Intercoms switch type field, select the switch:

  • Metakom

  • Vizit

  • Cyfral

  • Eltis

The Flat offset field is used to enter the apartment number in case the first apartment in the apartment block doesn’t start with 1.

Select Save matrix to save the settings.

When the matrix is being edited, a verification process is conducted to confirm that there is no overlap of apartment numbers within different apartment blocks located at the same address. This ensures the uniqueness of each apartment number within a specific address.

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.